356 A bezel for ignition switch

I need a fine bezel for my '59 Coupe. The current bezel does not grip onto the switch and it has been suggested to find another and create two set screws. Teflon tape was already tried without su...

Pre-A 356 Porsche crest OEM NOS

nos pre-a crest correct for your blunt handles late 54 to 55 , will also fit a standard pointed handle or a filed down pointed handle to look like a blunt . The pre a crest is the one on the bottom...

aft-P116a 4 Cam Generator Pulley Holding Wrench

What is shown in the picture is a faithful reproduction-including finish- of P116 from one version of the pictures of the Factory tools previously posted by Jon and Jacques. It has been reproduced...

aft-P50, aft-P50a [Back in Stock]

P50 and P50a are Factory designations for special tools to secure the oil line suction pipe to the crankcase. aft-P50 and aft P50a are Afterwerke reproductions of these tools that embody original ...

Horn Button Puller for 356, 356A

Having trouble removing the horn button from your 356 or 356 A steering wheel? I had this problem on my Speedster 82984. A previous owner had installed some of the steering column components inc...

Heater Control Rods

. . .”If you're driving your 356 this month, be sure the heater is adjusted properly!”* Chances are that this may be difficult if your heater control rods are missing or trashed [rusted and bent...

356C Emergency Brake Cable Housing Guide Bushing

Do you have sore or weak fingers from futile attempts to install the Factory part number 695.424.611.00 [guide ring for parking brake cable]? Or, are you disappointed to have found an OEM , NOS p...

Cap for tachometer shaft interface @ oil pump cover.

Often, there is a requirement to use an electric tachometer. A typical scenario might be use of an electrical tachometer while the mechanical tachometer was out for repair. Another might be if yo...

Alternative Steering Coupler for the C car

Afterwerke Corporation offers an alternative retrofitted design for the 356 C cars originally equipped with part number 695.47.201.00 This design uses one flex disc, a spacer, custom length fast...

Torque Multiplying Adapter for use with CIP1 Kits

The adapter in the picture, aft-TMA, can be used with the CIP1 variant of the original Torque-Meister. This adapter has been designed for use on both drum brake and disc brake cars. The adapter is ...